All stainless steel glass float flowmeter

Overview.

LZB/10D, 15D, 20D, 25D, 30D glass float flowmeter, citing foreign advanced technology, panel mounting, with flow control valve, its small size, lightweight structure, beautiful appearance, safe and reliable, simple installation. Suitable for working under lower pressure.

Installation and precautions.

◆ Flowmeter out of the box, should be carefully checked, has confirmed no damage during transportation.

◆The flowmeter must be installed in a vertical position (the angle between the center of the flowmeter and the plumb line does not exceed 5 degrees) and properly supported to prevent any stress transfer.

  For new installation pipeline in the installation of the flowmeter before the pipe should be flushed clean. Installation inlet is always at the smallest end of the cone pipe, that is, the smallest digital end of the connection.

◆In order to facilitate the replacement of parts during use, the flowmeter should be installed with sufficient space around it.

◆When the flowmeter is in use, the regulating valve should be opened slowly to prevent the float from hitting the glass tube with a sudden upward stroke and damaging the glass tube.

◆Float reading position for the float at the largest outer diameter.

◆The measured fluid and state (temperature, pressure) and the flowmeter index is not consistent, the value must be corrected according to the fluid and state at the time of use.

  In the use of the process of cone tube and float stained should be cleaned in time.

◆ Periodically check the error of the flowmeter. Once the error exceeds the specified, should follow the float and glass tube or recalibration.

分体型电磁流量计怎样调试在选购流量计后，假如调试，小编给你总结如下：流量计在调试前，运用管路及流量计开展完全查验，包含管路杂物等清理，油性物质管路不需要开展干躁解决。

调试前面板式流量计供应商应查验还包装电器路线的查验，先应对路线的接进开展检验，保证接地可靠后才可进行其他路线检测查验，以免导致路线溶性效用，存储电量，或者测量电源对仪器产生破坏作用。此外，还需开展绝缘电阻及绝缘电阻测试。

试压调试：不论是测量水性物质混悬剂体，还是油性物质的仪表，流量计在正式调试前，均应模拟具体测量物质的温度，压力，流速等条件开展试压调试。若在试压实验情况下发生异常，或者参数缺失，应对仪表开展单个检验或送出生产单位开展校检。